doors, drywall prep

Among today’s tasks

  • hang bathroom door
  • paint doors 
  • finish drywalling dormer window
  • trim around bedroom door
  • prep remaining ceilings for drywall 

Here’s the bathroom door before being hung. 

The dormer needs a ceiling and drywall on both sides. 

The wires have been secured and the poly taped. 

I measured from the window to the edge of the ceiling framing (like a joist) and then from the edge of the drywall to the center of the light hole.  Oops!  I should have measured to the side of the light hole.  More web taping for Dave. 

The bathroom door was hung a few mm off the floor.  I knew the floor was out, but I didn’t know it was out that much. 

I also added a spacer to accommodate the difference.  Adding 3/4″ of shims didn’t seem right. 

As for the bedroom door, this took some conversation, planning, and adapting the plan.  To use the off-angle bead, the drywall on both walls must match up properly.  Because of the 45° framing, the 45° angled wall (with the door) had to be built up.  Because of that, the door had to be adjusted out by 1/2″.  This whole thing should have taken less than a half hour, but it ended up taking about two hours. 

header above bedroom door 

Oops!  Normally the table saw barely notices hitting a nail, but this one was a substantial nail. 

The dormer ceiling was drywalled, and Dave mudded it. 

I meant to show a picture of the electrical panel being moved out 1/2″ to accommodate drywall.  Here it is. 

And now the top landing and stairway ceilings.  One light, for some reason, was wired around a rafter tie (ceiling joist), so I had to chase the wire back and reroute it.  I hate stapling wires in dusty attics over stairways. 

In scavenging lumber for everything, I found some writing.  “Lethbridge lumber?”  I can’t quite make it out.  The second one looks like someone was drawing a Charley Brown Christmas tree. 

Backing was put in for the top landing ceiling and stairway.  I need to get some metal brackets to do the other side as I cannot get the drill into the ceiling to mount the backing.  More updates as they come in. 

Completed: 

  • hang bathroom door
  • finish drywalling dormer window
  • trim around bedroom door

Partially completed:

  • prep remaining ceilings for drywall 

Not yet completed: 

  • paint doors